When I accidentally raised a dwarf rabbit,🥰
Part 2 Two young people look at the rabbit box and lollipop. In the quiet, there is a middle-aged woman asking the question, "How much did the cage buy?"
"180," the man standing at the node joined the conversation, "feeling that the rabbit cage is a little small." I bent down to look at the cage. Yeah, actually. Hey, this is a bird cage, haha. Why doesn't it have a bird in the middle of the cage for the bird to perch?
Dead!
What breed of rabbit does not ask, buy because the baby says cute, want to raise, only know the name of the dwarf rabbit.
I had to do it myself. I figured out two dwarf rabbits.
The cage itself has to be 70 cm high. It is 90 cm long to suit two rabbits. Because the rabbits have to have space to run (prevent stress). I can stand.
I cut four 70 centimeters tall trees.
90 centimeters long, 8 trees.
Behind the wall, I was closed with solid wood.
Above the cage, I closed a solid roof.
Why do you have to do this? Because the rabbit instinct is careful of the top of the head. In fact, it faces a predator who is a bird, so I close it on the back of the cage, behind the cage, I close the solid wood as well and put it against the wall. Why close the solid wood? Because the rabbit will feel safe, there is a place to power.
If we were a rabbit sitting in a cage, looking outside, we would see the front, the left, the right.
My cage floor is flat for easy walking. If the cage is grated, the rabbit's leg can fall into a broken groove and be injured.
I used a steel wall, I could buy it in a building shop, I could choose an eye that wasn't big, so I couldn't get it out. It cost 60 meters. I bought it for 6 meters, a height of 70 cm, a length of 90. The grate could be wrapped around the cage.
The excess is cut off. The hair grill bracket uses a black threaded nail to bore into the plastic soft drink lid. The holding time is very tight. How to make the cage mesh pretty taut. Use a steel to rock the cage taut and use a lock. Make the top four corners first and then scavenge the bottom to get a beautiful taut cage.
In front of the entrance cage, you have to make it easy to use a grass crumb broom + rabbit shit. Use the rest of the crumbs to make a door open in and out by folding the crumbs of the cage slightly bigger than the entrance. The top is tied with three corners of wire, left, center, right, open up and down.
The bottom is made at the lock of the cage using a thin steel plate to make a drill hole next to the cage on both sides, and then a wooden or steel bar can make a cage door polisher.
Continue reading part 3


































































