Okay, so you've seen my journey with House Renovation Part 36 where I tackled the infamous wall-to-ceiling corners using FIBATAPE. It's a game-changer for DIY drywall, but let me tell you, there are definitely a few things I learned the hard way! First off, why FIBATAPE? I chose it because it's self-adhesive, which is a HUGE help when you're working overhead or alone. No more pre-wetting paper tape or struggling to hold it in place while applying your first coat of mud. It's especially forgiving in those tricky ceiling situation spots where gravity is not your friend. I used it everywhere, particularly where I had some small gaps or slightly uneven surfaces – it really helps to bridge those imperfections. My biggest tip for using FIBATAPE effectively, especially in those tight wall-to-ceiling corners, is to ensure the surface is as clean and dust-free as possible. Even though it's self-adhesive, dust can compromise its stick. I learned this when I had a small section peel back slightly on me. Live and learn, right? Next, applying it. Don't stretch it too tight; you want it to lay flat and conform to the corner. For inside corners, I found it helpful to gently fold it down the middle lengthwise before applying, creating a natural crease that fits snugly into the corner. Then, press it firmly with a putty knife or your hand to ensure good adhesion. This is crucial for a smooth base. Now, for the mudding – this is where you really make or break your drywall fix. FIBATAPE requires a setting-type joint compound (hot mud) for the first coat, as it's fiberglass and setting compounds adhere better and harden faster. This is important, especially if you're asking, 'Can we fix it?' after noticing some initial issues. Don't skimp on this step! Apply a thin, even coat, pressing the mud through the mesh. You want to fill those holes and embed the tape. For those ceiling situation areas, I found applying the mud in thinner layers helped prevent sagging. After that first coat dries (and it dries fast!), you can switch to an all-purpose joint compound for subsequent coats. Feather out your mud coats wider and wider with each layer to blend the repair seamlessly into the existing wall and ceiling. Sanding is key here. I always recommend using a sanding sponge for corners to maintain that crisp line without over-sanding. My personal takeaway from this House Renovation phase? Patience is your best friend. Those wall-to-ceiling corners might seem intimidating, but with FIBATAPE and a bit of careful mudding, you absolutely can fix it and achieve results you'll be proud of. It transformed a potentially frustrating part of my renovation into something manageable and rewarding!