Bambu P1S two piece Mandalorian print
Here is the first large two piece print off of the Bambu P1S printer. Bonus points if you can tell me what it is.
I am planning to glue these together with Starbond CA glue. Any advice you have on the best way to hold these pieces together when gluing would be greatly appreciated as they slide very easily on each other.
When assembling large two-piece 3D prints like this Mandalorian model from the Bambu P1S printer, one of the biggest challenges is holding the pieces steady while the glue sets, especially if the surfaces are smooth resin that tends to slide easily. From my experience with resin 3D printing and gluing, here are some practical tips that worked well: First, ensure that the contact surfaces are properly prepared. Gently sanding them with fine-grit sandpaper increases the surface area for better adhesion and reduces sliding. Next, consider using clamps or even simple elastic bands to hold the pieces together firmly during curing. Position the print on a flat surface to keep alignment precise. Starbond CA glue is excellent for resin prints due to its fast-curing properties and strong bond. Using accelerator spray can speed up curing, but be careful not to overspray as it can cause brittle joints. Applying a thin, even layer of glue prevents oozing and mess. If clamps aren’t suitable, temporary supports like Blu Tack or modeling clay applied strategically can hold parts in place without damaging the print. Lastly, patience is key — allowing full curing time as recommended by the glue manufacturer ensures a strong, durable bond that will keep your Mandalorian piece securely assembled for display or further finishing work. These tips helped me successfully assemble large resin prints without slippage or misalignment, resulting in seamless, impressive models. I hope they help you with your Bambu P1S Mandalorian project!